zupanj
Well-Known Member
Anyone have experience with adjusting a hydraulic roller cam. I assume it's the same as any hydraulic lifter but I am not sure. I took the right side valve cover off because there is enough valve train noise that I was afraid I wasn't oiling. It looks like the head is getting plenty of oil but I think at least a couple of intake adjustments were off. I could spin the roller on the #6 rocker arm and could almost but not quite get a 0.008" feeler gauge to go under the roller. I set the adjustment so I turned a quarter turn after the roller stopped spinning. Is this correct? I hit a starter and then #4 had the same adjustment. It has been more than 40 years since I played with valve adjustment and then it was with solid lifters. I want to be sure I am doing this correctly.
Jack
Jack