Hey guys, I called Edelbrock and they couldn't help me so thought I'd ask here. Edelbrock told me that for every .005 of flat milling on the heads, I would get approximately a 1cc reduction in chamber volume. Is there a similar estimation for angle milling?
Heads OOTB have an 84cc chamber. I want to bring it to 75cc. The machinist told me that if he takes .050 angle milling off the heads, we'll get there.
He's also going to shave the intake and recheck geometry, pushrods, etc.
Thanks,
John
Heads OOTB have an 84cc chamber. I want to bring it to 75cc. The machinist told me that if he takes .050 angle milling off the heads, we'll get there.
He's also going to shave the intake and recheck geometry, pushrods, etc.
Thanks,
John