Pesky heater box cable clips.

Jack R · Aug 2, 2020

These come off easy. What is trick to get them back on with the new cables?

I”ll be done with the heater box once these are secured.

69hemibeep · Aug 2, 2020

Do you have the screw that goes threw it?

Jack R · Aug 2, 2020

No screw in that one......or any of the others on the heater box. The vent box cable clip has a screw in it though? The clips bent Easy to remove but might be a 3 hand job to re install. The design is good, don’t really need a screw if you can get the hold tab positioned under the bracket. I’ll try a screw to see if that will draw it down.

Jack R · Aug 2, 2020

Even the clip with the screw has the same configuration with the small tab that Attaches under the bracket. But using a screw does secure the heater box cables without the tab going under the bracket. I hate to leave it like that though.

dmartin · Aug 2, 2020

I think it just snaps in place I really don’t remember

droptop · Aug 2, 2020

RGAZ · Aug 4, 2020

They snap down when you push them. Most have a retention screw that goes through the hole shown. Sometimes if they don't snap down I use a pliers to "coax" them around the tab.
RGAZ

Pesky heater box cable clips.

Jack R

Well-Known Member

69hemibeep

Sponge Bob Square Wheels

Jack R

Well-Known Member

Jack R

Well-Known Member

dmartin

Well-Known Member

droptop

Well-Known Member

RGAZ

Active Member