sam z
Well-Known Member
Guys,
Picked up a set of ET IV slot mags, very pleased with them. They are cleaning up ok, but I have one that is being
a SOB. Little "black marks" on it that I've been trying to bust off with no luck.
I wet sanded with 220 grit paper, it helped, but they are still too prominent.
I was thinking of getting a few scotch brights that attach to the drill but if
you have any better ideas share them.
FYI: They were scrubbed with Scotch brights w/polish, sanded with 400, 320 and then
220, still the spots remain. They aren't hideous, but they have to go.
Picked up a set of ET IV slot mags, very pleased with them. They are cleaning up ok, but I have one that is being
a SOB. Little "black marks" on it that I've been trying to bust off with no luck.
I wet sanded with 220 grit paper, it helped, but they are still too prominent.
I was thinking of getting a few scotch brights that attach to the drill but if
you have any better ideas share them.
FYI: They were scrubbed with Scotch brights w/polish, sanded with 400, 320 and then
220, still the spots remain. They aren't hideous, but they have to go.