Recent content by jaxrunner1968

I have a 69 Date code 383hp engine, stock heads, Stock 4 bbl manifold, have engine build sheet and video of engine running before pulling. Also have a set of like new TTI headers. Shipping not included. Located in Jax Florida. Engine: Asking $1,200. Headers: Asking $600.

Thanks guys, I tried to install with the fiber gasket between the intake and valley pan, could not get it to fit....I was told to try and remove the fiber gaskets and bolt it down directly to the valley pan. They said if heads have had any work and been cut that could be the issue. Is there any...

Hey guys: I plan on installing this intake on my 383 with stock heads. Purchased a Fel-Pro 1214 gasket kit which comes with (4) fiber gaskets and a new valley pan. Could you provide any advice on what areas to use RTV sealant, some say just between new gasket and heads and no place else. Thanks!

I know this post is pretty old but are these still available? I am looking to install a 4 spd in my car and will also need bell housing, flywheel, and other misc parts. Let me what parts you might have thanks.

Is the case and sure grip still available?

Hey cj! How is the car been running? I purchased a 1970 CUDA I have been working on trying to get in order to sell. Nice ride but they can have them E-Bodies!!! Hope to see you at one of the shows soon.

I have a pair of right and left pillar post trim pieces and both are in excellent condition but have no idea what they fit?? These are NOS parts and have a PT 2895469 number stamped on each. Anyone have any idea how to search the numbers to find out? I have tried mymopar and a couple other sites...

Thanks for that information, I purchased a few small tools may help. On the male end that has one side that looks like a knive blade, would inserting a small tool into one side of the block disengage it from the female connector so I can pull it out?

Thanks, I did find a harness that had those terminals on one end so I will get that one. I assume that the firewall block terminal has to be unplugged in order to get the (2) old wires out and the wire connections in correct? Thanks again for the help!

Hello; Has anyone ever replaced separate wires out of the firewall main electrical block? I have a bad brown wire on the three wire safety sw/back up light harness and want to install a new harness but need to be able to plug them into existing firewall block. Thanks for any help with this!

:lol:

I need to reach out to some professionals out there on this one: I have 4 wheel manual drum brakes and am converting to manual front disc. I have purchased a POL front disc conversion kit and a Summit PV-2 Proportioning valve to do this job. Mancini tech tells me to see how the brakes feel...

Welcome!

Welcome from North FL!