Recent content by tvtn

I'd prefer original, but I'm not too picky.

Does anyone have an opinion on interior redo for a 69 coupe RR? Should I buy premade seat covers, headliner, and carpet, or have an upholistery shop provide material and labor? What is the best place to buy premade stuff? Need your help! Tom

I have a nice (driver) lower dash pad from a 69 RR, let me know if you are still looking. Tom

Does anyone know a source for the springs that tension the brushes in the motor? 1969 RR with 3 speed wiper.

I'm cleaning up unused holes on the engine compartment area on my 69 RR. Battery holder holes filled, it will be in trunk, as well as a one wire alt (no outboard regulator). I suppose someone has posted pics of what holes are for????? but can't seem to locate. Lohanks for your help. Tom

I have a 69 RR that was a 4 speed, and will be an auto. My question is how could I use the existing hole in the floor to mount a floor shifter? Please share your ideas on how to use what is there? or what you did to mount your shifter. Tom

I know, this is not a RR but I need to know if a friends 65 Coronet has some of the steering components installed incorrectly. His parts that pass over the header tubes have the zerk sides up. The only car I have seen to compare is an A body and the zerks face down. Anyone have a picture of the...

I posted looking for panel or door paint jigs and came up with one myself. This started as my engine stand with the center fixture removed. I put a surplus piece of pipe thru the stand into the gutted door's latch hole and attached the far end to the holes in the middle of the door. A longer...

Has anyone built their own door repair/painting stand. It could be a stand alone type or something to go into an engine stand? I'd like to see your finished projects or ideas. I would like to be able to have access to most of the door without putting it on something. Thanks Tom