Search results for query: *

I just saw this, what insulation are you using

Quikbird, where would I get one of those baffles. Thanks

They are OE covers. I appreciate you guys input. Thanks

Upon further examination, it looks like the end of a small cable tie got caught under the top front corner of the valve cover. This happened when I was reinstalling the cover. I’ve taken the cover back off will reinstall when the new gasket comes in. I also discovered the cover isn’t fitting...

Still checking several things, thanks for your suggestions.

I recently replaced my PCV valve, since then I’m seeing oil droplets in the engine bay. The valve is tight in the grommet and grommet is tight in the valve cover. Even before I replaced the valve I’ve had a smell in the car that I thought was gas but it may be oil from the crankcase. I’ve...

Where’s the best place to buy one. Do you size it out and buy at auto store?

Thanks, I pulled harder.

Glad I found this. I’m having the same problem removing my pcv. The grommet is as hard as a rock, didn’t realize it was rubber. So it just takes force. Thanks for this information, I like you, have spent a lot of time researching this before finding this post.

Could a bad pcv valve causing my fume problem? I want to replace it, but having difficulty removing it from valve cover. What is the procedure? Thanks

Thanks guys, you have given me some things to check out.

When I bought the car about 6 years ago the Holley ran pretty good, however the last 3 years or so it has not run so well. Maybe I should give it another chance, but I really don’t know what to do. Since it ran ok before, I don’t think the jetting is a problem. The air mixture screws are...

Sorry, didn’t finish. Hesitates even after it gets warm, heavy fumes inside car. I just want a carb that works. I’ve taken the car to a “Holley expect” no help. My Mopar buddies say to get a Edelbrock. Any suggestions on type and cfms?

I also have a stock 69 383 with a Holley 670 Street Avenger. This carb isn’t working for me. Hard to start, hesitation even

You didn't list Bahama Yellow, listed on finder tag as 999

I replaced the right side with a Fel-Pro rubber gasket 2 years ago and it's leaking again. I've got everything cleaned up, but I want to use another type gasket. I'm hesitant to use cork. Any suggestions. Someone mentioned a rubber over steel gasket.

Please check the width, mine are 6" wide. I'm located in southwest Virginia. Thanks

I need a wheel, one of mine is bent. It's a 14"x 6". I'm not sure what the proper name of the wheels that came from the factory on most of the RRs. I always referred to them as road wheels, they came with the beauty ring (don't need the ring).

Leak getting worse, time to replace. What is the procedure. Can this be done without dropping the 4 speed tranny?

Thanks guys for the info. TOMRR, I sent you a message, not sure I did correctly. Semper Fi