Search results for query: *

I installed both AMD full quarters but I not familiar with the OER ones, the AMD ones did need some work to fit correctly but I have never found an aftermarket panel that fit perfect.. I would not do a quarter skin (what you called a short quarter) as there is a big seam to weld and finish, the...

Threw the trunk lid up on a stand and started peeling back the lower lip. I knew it was swelled from rust but wasn't sure how bad, when I opened it up I knew there was no chance of saving it as it literally started peeling off along the edge. I'm not sure what if I'm going to fix it, try and...

Got some NOS rebuild kits off e-bay fairly cheap for my rear wheel cylinders but upon disassembly I found water/fluid mix which caused rust pits in the bores. I'm currently looking for some good used ones with the correct part number.

Passenger door primed.

Need two good wheel cylinders for my `70 as mine are too pitted in the bore to use. Price plus shipping to 03825. Thanks!

Not sure what part you are missing?

This guy is very knowledgable on wiring and has some good info - way beyond my understanding of electrical stuff.

I have owned many old Mopars since 1979 and I have never had or even seen one that had a fire caused by the ammeter but I guessit does happen. IMO if all your wiring and connectors are in good shape and not corroded and you don't have too much extra strain on the system like big draw stereos...

Hopefully the last skim and I can get epoxy on it tomorrow or Saturday. Also skimmed a slight wave on the roof.

Great work!

Welcome! What are the plans for it - back to stock or modified?

Obviously do not bring it back to that shop EVER! It`s up to you if it`s worth your time and effort to take them to small claims court. Me - I would consider it a loss and move on but bad mouth that shop every time I could for decades (Jim`s Auto Parts and Hagerty are my two). I see you are down...

`74 I restored in early `90`s, just a 318, 904, was pea green on green, stripe delete with vinyl roof but I went `71 J6 Sassy Grass. The 318 was stock but I added dual exhaust. It was a nice driver and I would have added 4 barrell or swapped in a 360 if I kept it but had to sell to save up...

Passenger outside is not as nice, small rust spots in lower front that blow thru but still overall pretty nice .

Welcome! I`ve had a few `73-74 Satellites and road runners, details on yours? And be sure to start a restoration thread so we can see your progress.

Passenger door cleaned and epoxied on the inside along with the outside of drivers door. Next is to strip outside of passenger door.

Missing or Damaged Retaining Clip/Snap Ring: The most common cause is a missing or dislodged snap ring or clip that holds the upper steering column bearing in place. Worn or Damaged Upper Bearing: The bearing itself might be worn out, allowing for excess movement. Sheared Plastic Rivets: The...

Very nice! Love the wheel choice as well.

Not sure if you finished with this area but to me it looks like the area around the hole is sill bent and needs to be straightened out a bit more?

Not sure what you have for bodywork tools but if you don`t have a hammer and dolly set invest in one, even a cheap Harbor Freight set would be fine and it will make metal working easier A little heat with a propane or map gas torch will help with the stubborn areas but sometimes a relief cut is...