`70 road runner - finally getting to the restoration!

[torredcuda]

Doors corners are really clean but looks like some previous owner tried to jack the car with the drivers one.

 

[torredcuda]

Straightened, skimmed and sanded down ready for epoxy.

 

[torredcuda]

Hinges and door are in epoxy, I'll start assembling the hinges after they have a day to dry.

 

[torredcuda]

Not sure why my pics are upside down all of the sudden???

 

[torredcuda]

Stripped the outside and happy to find nice clean metal. A couple hours with stud gun, body file and hammer and dolly straighted out the dings and dents.

 

[1968 man]

Hinges and door are in epoxy, I'll start assembling the hinges after they have a day to dry.

View attachment 39506

View attachment 39507

Fixed it for you

 

[torredcuda]

Thanks! It`s weird the same pics posted fine on FBBO but upside down here. never had an issue with that before?

 

[torredcuda]

Passenger door cleaned and epoxied on the inside along with the outside of drivers door. Next is to strip outside of passenger door.

 

[torredcuda]

Passenger outside is not as nice, small rust spots in lower front that blow thru but still overall pretty nice .

 

[torredcuda]

Hopefully the last skim and I can get epoxy on it tomorrow or Saturday. Also skimmed a slight wave on the roof.

 

[torredcuda]

Passenger door primed.

 

[torredcuda]

Got some NOS rebuild kits off e-bay fairly cheap for my rear wheel cylinders but upon disassembly I found water/fluid mix which caused rust pits in the bores. I'm currently looking for some good used ones with the correct part number.

 

[torredcuda]

Threw the trunk lid up on a stand and started peeling back the lower lip. I knew it was swelled from rust but wasn't sure how bad, when I opened it up I knew there was no chance of saving it as it literally started peeling off along the edge. I'm not sure what if I'm going to fix it, try and find a good used one or go with a new AMD panel?