My Bird

[4spd69RR]

Here are a couple of shots after backing the RR out of it's nest. Had to sweep the floor so I could replace the Clutch, Pressure Plate, and Thowout Bearing. Just wanted to share!

 

[Roadcuda]

Great lookin car you have there!

 

[69hemibeep]

Sweet

 

[moparchris]

Sweet

X2

 

[Steve]

Very nice,your garage is about the same size as mine too.

 

[Hoosier Bird]

 

[ACME A12]

Very nice,your garage is about the same size as mine too.

But the driveway looks significantly less challenging... :basketcase:


Nice Pics! :cheers:

:jester:

 

[solid gold]

Nice!

 

[4spd69RR]

Thanks all, yes the garage is a bit small. Just enough room to walk on both sides, it is pretty deep though. One issue I have discovered is the previous owner use either an E or A body trans cross member support. So I am in search for a B body support. I did not realize this until I dropped the trans. Any of you have an extra sitting around! Attached are a couple of the Clutch assy installed.

 

[moparstuart]

Thanks all, yes the garage is a bit small. Just enough room to walk on both sides, it is pretty deep though. One issue I have discovered is the previous owner use either an E or A body trans cross member support. So I am in search for a B body support. I did not realize this until I dropped the trans. Any of you have an extra sitting around! Attached are a couple of the Clutch assy installed.

nice flux capacitor

 

[4spd69RR]

Thanks, had a time getting it all aligned. I'm sure it will definitely take me to 88 mph and beyond.

 

[Basketcase]

:drool:

 

[abodybill]

Glad to see it's in and done. :yesnod:

Take it out and give it agood test :yesnod: