chargerbelgium
Active Member
Hi there, I have installed the passenger side header without any problem but the drivers side won't fit. The installation procedures says to remove the dr side engine mount fastener and raise the engine 1 1/2 "
Can someone please point out which fastner they refer too? And is it only the front mount or rear mount too?
I install the headers from under the car, the RR is lifted on blocks on the 4 corners.
Hope to read a quick response so I can install the header today.
Thanks a lot! CB
Can someone please point out which fastner they refer too? And is it only the front mount or rear mount too?
I install the headers from under the car, the RR is lifted on blocks on the 4 corners.
Hope to read a quick response so I can install the header today.
Thanks a lot! CB