Windshield Wipers Not Symmetrical

69RNR

69RNR

Well-Known Member
Joined
Nov 28, 2016
Messages
116
Reaction score
2
Location
Utah
A LOT of you were kind enough to help me get these working, but they are "off". If you look at the drivers side you tell it's higher than the passengers. When I run 'em the drivers side goes off the windshield. Can anybody tell me where that adjustment is made? As always, thank you in advance.
0c210c641c4a6a51b6d8effb10f363b4.jpg


Sent from my SM-G935P using Tapatalk
 
You should be able to take back off and turn it to match the other one


Sent from my iPhone using Tapatalk
 
pull the wiper arm off the pivot (careful not to scratch the paint!) and adjust as needed.and I'd say the passenger arm needs up a touch.
 
Agreed. The pass side is to low (hitting the trim) and the driver side is to high. Lift the arm and slide the locking tab out to unload the spring. You should then be able to remove from the shaft and relocate them in the proper positions.
 
Last edited:
I'm with drop top on that one. They make a tool for taking them off but don't know what it looks like. Some of them use to use a bent screw drive to push the clip. Well cant have wiper's not in sink. Russ. :applouse:
 
I'm going to break this bastard. I pulling that tab back but it won't slide off! I got pissed and walked away. :brickwall: I'll try again this weekend.
 
you need to move the tab back, and pry the wiper arm up at the same time...side to side. and be mindful of the paint. swing by, I'll give you a hand...:jester:
 
my car may not be painted...but my wipers work. :acme:
 
Yea man when you get mad or frustrated at your bird, man just walk away cause if your like me I tend to tear up stuff when things go awry and it can get costly


Sent from my iPhone using Tapatalk
 
dmartin said:
Yea man when you get mad or frustrated at your bird, man just walk away cause if your like me I tend to tear up stuff when things go awry and it can get costly


Sent from my iPhone using Tapatalk
Click to expand...
Yep! Already happened to me with my window vent. Used the channel locks to turn the lever and snapped that bastard right off! Wonder what that'll cost me!
d2b5195d25ad2ee58a862af9230c3ebb.jpg


Sent from my SM-G935P using Tapatalk
 
TOMRR said:
HPIM4690.gif

You Need One Of These !!
Click to expand...

I have one of those. It was on that big tool trailer at Carlisle and just a couple bucks... I couldn't pass it up.
 
69RNR said:
Yep! Already happened to me with my window vent. Used the channel locks to turn the lever and snapped that bastard right off! Wonder what that'll cost me!
d2b5195d25ad2ee58a862af9230c3ebb.jpg


Sent from my SM-G935P using Tapatalk
Click to expand...

I'll look tomorrow to see if I have an extra one


Sent from my iPhone using Tapatalk
 
You must log in or register to reply here.
Back
Top