rkb2
Well-Known Member
:huh: Ok so it's been about 30 years since my bird has seen the road and I'm trying to get her there again. Had no motor and trans when I got but was already set up for a 4 speed although originally an auto car. I parted another four speed bird years ago and have been saving parts all these years. The Z-bar that was in my parts collection won't fit between the ball studs it's too long. As the four speed parts may have been added wrong can anyone give my the width of the z-bar in case I have the wrong one and the measurement between the ball studs in case I have some work to do. Also a picture of the way the linkage goes on from a stock shifter and 4 speed trans. I have the brackets with the rods underneath on the trans but in looking at some adds feel this may be upside down. Any help awould be great. Thanks Ron :lock: