Recent content by wagonman

Door Locks?

I just got done with the same issues as you have. Yeah hands to big so I pulled the IP cluster and found the pins loose for the round plug. Got a new board with the solid state Voltage Regulator and all is good now. Hookup the plug to the cluster as you are snaking back in,no way I could get it...

Just got done with this on my 68 hood. It is called anti flutter. Kind of like expandable foam. I used Worth black RTV in a cheese wizz can. Go slowly and fill it in, make sure the metal is super clean. Clean up the excess let it setup and then paint. I guess the Low expanding foam would work...

So I picked up a couple of the 833s with the bolt on rear flange. IDK what years thinking pre 66. Can you cut off the threaded stub on the output shaft and use them with the slip yolk type shaft??

Where can I buy the clips that hold the molding at the top of the windsheild/ head liner. I got some from a vendor but they junk.Looking for NOS. Any leads?? Thanks.

Thanks I have bought from him before.

Well I got a used pair of these little buggers on the cheap. The housings are nice but the guts are shot. I seem to remember seeing them for sale somewhere like E-bay. A recent search turned up nada. These units are the ones that have a set screw to hold it together and not the ones with the...

Well I am installing the headliner in my 68 post car. I am to the sail panel area and am wondering if it takes a board for the material to attach to?? I see them listed in the Classic book but dont see how they would attach. It looks like the 69s have a metal bracket. Am I missing this bracket...

Thanks for the info. Now I need to drain the tank to find out whats what.

Hey Beep got a spec on the sender like how many Ohms at empty and full. Having the same issue with my gauge. It has a new tank and sender. I know the repop senders can have calibration issues. I can pull the sender wire and the gauge swings all the way to full and when grounded goes to empty.

Yeah Beep 3 speaker but 8 track nope. Going with a retro sound thumbwheel. Had to pull the cluster to replace the circuit board now all gauges lites ect work. Still have to sort out the rest of the dash wiring like the dome lites. I will be asking some Qs.

All panels are in primer and rear window and trunk are repaired. Time to prep and seal the body. Lots of sanding in my future.

I have used Partsmix, good guys for stuff like bolts and the things everyone else sells. And you can actually get them on the phone.

Thanks, will check their page.

Yes beep, milled and decked. Probably leave the passages open, gets a little cold here. I will check manifold fit with and without gasket to get an idea how it sits.