Search results for query: *

What side sets on the head? The rounded edge side or the flat edge side of the valve cover gasket?

Is cork the best gasket for valve covers. And also thank you all for the great knowledge and advice. I have learned so much.

Do I have to run a PCV valve? 440 Eldelbock RPM package. The handles are breathers. And the hose just goes to the front of the carb.

Sorry took so long to respond. Between carb and fuel pump.

What is a good fuel filter and where is the best place to install it? Before or after fuel pump?

Thanks

Now that all of useless rear suspension crap is gone, I’m considering an inexpensive Jeggs or Summit rear sway bar with the KYB gas shocks I installed. Does that sound reasonable?

Thanks to all of your suggestions I Took all of this off. KYB gas adjust is all that’s on her now.

So I'm ditching the High Jacker air shocks. I drive the car to and from shows and around town. Looking for suggestions for replacements. I have KYB gas adjust up front.

And no not lowrider low.

Lower the rear body 2 inches or so. To get the stance I want I have to raise the front end higher than I want it. So lowering the rear 2 inches should be just about right.

This is the Rearend set up that came with the car. Coil springs and air shocks. I’m assuming 8 3/4. I’m still going through all of the paperwork and receipts figuring everything out. What is this rear end setup called? I can’t lower as much as I’d like without letting the air out of the shocks...

Figured that was the case. Thanks for validating.

Is there a way to find out what dealership my roadrunner was first shipped to and sold?

Thanks everybody. Great info.

Yes to the coil it’s an Msd blaster2, msd 6 amp ignition control and msd pro billet distributor.

What’s done with wires if no longer used?

What does the ballast resistor do if I run a Mallory EI. Is it still needed?

Torsion bar adjustment clockwise a turn or two.