xcmtbjason
Member
Does anyone know the vertical location of the center of gravity for just the bare uni-body? I'm building a rotisserie to spin the car and my first attempt, which I foolishly centered top to bottom resulted in the car being way out of balance when turned sideways. I am using a 30:1 gearbox, and it cranked pretty hard when the car was at 90 degrees... It did work, but I'm going to rework the setup so its better balanced when on it's side.
I'll of course post some pics and put a video out on youtube when I get it done. In the meantime though if anyone has any experience with where to place the roll center that would be really helpful as my next attempt will just be a guess, which at least will be closer and hopefully close enough because I don't plan to cut it apart for a 2nd time...
Thanks,
-Jason
I'll of course post some pics and put a video out on youtube when I get it done. In the meantime though if anyone has any experience with where to place the roll center that would be really helpful as my next attempt will just be a guess, which at least will be closer and hopefully close enough because I don't plan to cut it apart for a 2nd time...
Thanks,
-Jason