Hoosier Bird
Well-Known Member
Before I take the time to trig it out, someone on here once posted how much to mill off of the Intake side of the head per every .02 taken off of the head..........please help :worship:
Milling Head
- Thread starter Hoosier Bird
- Start date
mcmopar
Well-Known Member
I believe the correct amount is .012" off the intake face for every .010" off the combustion chamber surface. Can anyone verify this?
Hoosier Bird
Well-Known Member
I think your right. I came up with .0123 off the intake for every .01 off the head. .0042 on the 906 head should be 1cc. Let the games begin......I shouldn't need to remove much. 
droptop
Well-Known Member
I took 30 off the 906 heads that I put on my '75 with out taking any off of the intake. No problems at all. I did use the thicker head gaskets instead of the metal shims. I was told by the machine shop that you can go up to 50 with out problems, but I thought that would be to much.
Hoosier Bird
Well-Known Member
I may use some high spot blue and see where my port falls on the intake. Since I just gasket matched I would like for it to line up pretty good.