Turn Signal Swith

69RRJohn

69RRJohn

Member
Joined
Mar 7, 2021
Messages
12
Reaction score
13
Hi everyone, just joined after acquiring my first bird, a 69 numbers matching RR Hardtop. Some tweaking required of course.....any ideas on how to get to the turn signal switch (suspect just needs tightening) without removing the steering wheel? The switch lever is floppy and doesn't engage.
 
Welcome from Fla. The turn signal lever attaches with a screw. I replaced the lever and the switch when doing the steering column. Yes pull the steering wheel. Not that bad of job. Used a steering wheel puller. When putting it back make sure the large spline lines up with steering wheel. Good luck.
 
Russ69Runner said:
Welcome from Fla. The turn signal lever attaches with a screw. I replaced the lever and the switch when doing the steering column. Yes pull the steering wheel. Not that bad of job. Used a steering wheel puller. When putting it back make sure the large spline lines up with steering wheel. Good luck.
Click to expand...
Thanks, it's what I thought. I WAS able to remove the horn RR cap and the horn pad and with a small thin screwdriver, tighten the screw which secures the lever. It wasn't easy but did get it to tighten. Temporary band-aid until I source a wheel puller. Thanks again!
 
69RRJohn said:
Hi everyone, just joined after acquiring my first bird, a 69 numbers matching RR Hardtop. Some tweaking required of course.....any ideas on how to get to the turn signal switch (suspect just needs tightening) without removing the steering wheel? The switch lever is floppy and doesn't engage.
Click to expand...
Unfortunately the wheel has to come off
 
You must log in or register to reply here.
Back
Top