• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Search results

  1. Mike D

    What side down fel pro Valve cover gasket

    What side sets on the head? The rounded edge side or the flat edge side of the valve cover gasket?
  2. Mike D

    Valve cover gasket recommendations & thanks for all the advice!

    Is cork the best gasket for valve covers. And also thank you all for the great knowledge and advice. I have learned so much.
  3. Mike D

    PCV valve

    Do I have to run a PCV valve? 440 Eldelbock RPM package. The handles are breathers. And the hose just goes to the front of the carb.
  4. Mike D

    Fuel filter recommendations

    What is a good fuel filter and where is the best place to install it? Before or after fuel pump?
  5. Mike D

    Rear sway bar suggestions

    Now that all of useless rear suspension crap is gone, I’m considering an inexpensive Jeggs or Summit rear sway bar with the KYB gas shocks I installed. Does that sound reasonable?
  6. Mike D

    Thanks everybody for the advice.

    Thanks to all of your suggestions I Took all of this off. KYB gas adjust is all that’s on her now.
  7. Mike D

    Suggestions for rear shocks

    So I'm ditching the High Jacker air shocks. I drive the car to and from shows and around town. Looking for suggestions for replacements. I have KYB gas adjust up front.
  8. Mike D

    What is this setup?

    This is the Rearend set up that came with the car. Coil springs and air shocks. I’m assuming 8 3/4. I’m still going through all of the paperwork and receipts figuring everything out. What is this rear end setup called? I can’t lower as much as I’d like without letting the air out of the shocks...
  9. Mike D

    What dealership first sold my roadrunner?

    Is there a way to find out what dealership my roadrunner was first shipped to and sold?
  10. Mike D

    Mallory EI and ballast resistor

    What does the ballast resistor do if I run a Mallory EI. Is it still needed?
  11. Mike D

    Raising and alignment

    Hello all! If I raise my roadrunner 1 inch will I need an alignment?
  12. Mike D

    Can I use 70 LCA’s on my 69

    from what i can tell only the sway bar mount is placed different. can i still use 70’s. any modification for the sway bar? thank you mike
  13. Mike D

    Need lower control arms w/ sway bar mount

    Hello all! I am looking for both lower control arms prefer rebuilt. Any leads would be much appreciated! mike
  14. Mike D

    My horn is possessed!

    My horn will beep sometimes while turning. Even with the horn button completely removed.
  15. Mike D

    What is this piece called.

    Hey there! I’m looking for this missing trim piece and don’t know what it’s called. I need passenger side 69 Roadrunner.
  16. Mike D

    What is this piece called?

    Hello and thank you for accepting my request to join. I’m trying find out what this missing piece is called so I can try and find one. For my 1969 RoadRunner.
Back
Top