rebuilding a 1969 hemi in the netherlands

High ratio is kind of opposite what you might think. Ratios like 4:10, or 3:73 are considered
“ tall “ or lower gear. These gears accelerate faster but have a lower top end speed. Ratios like 3:23, or 2:74 are considered short or higher gears. These gears accelerate a little slower but have higher top end speed. Better mileage also
 
Oke read about changing gearbox to a 4 speed automatic anyone expert on this?
 
Might need to change trans tunnel, change pedals, change steering column, unless use console and floor shifter, need cooling attachment in radiator, cooling lines, need flex plate swap from clutch and flywheel, think drive shaft stays same length, if new 4 gear auto might need controller for it, many are electronic controlled. Possible new trans crossmember. Help me out if I forget anything.
 
Sorry nothing is easy. Putting this car I have back to four speed and adding console. Just lucky it was a four speed original car. Some one had put an automatic in her and did a hatch job on the Z bar hanger on the frame rail. Had to fix all that. Needless to say did not have bell housing but the clutch pedal was still in the car. Keep the pic's coming on how your doing. :beep:
 
Don't even know if you can get any thing plated here in the USA. Are they cadmium plated. Look really clean and shinny.
 
I can do that zinc plate but some of it should be black phosphate to be correct like the fender bolts and keepers but they get painted anyway
 
Getting things plates here is getting harder chemical acid bla bla bla....
I know some of it should be black but bling bling and meep meep sound nice
Anyone experiamce with choke’s who are taken off the carb and rebuilding those

2D107807-D3EC-4729-BB2A-D4E6E9E0318D.jpeg
 
Rebuilding the carb's are not that hard. Get a kit and they are pretty straight forward. Soak in a pail of carb cleaner disassembled. Is the choke electrical or vacuum operated. The choke mech I have always bought new and replaced. Hope some one else will let you know if they have the same type of carb's you have that will help. Good luck. :steering:
 
Thanks
Rebuilding the dash start by making the promis to my doughter to pick her op at 3:00 so she will paint the letters of my dash looks great i think

62441EE0-3842-4929-9443-32BEE14C0F75.jpeg
 
Getting the spagetti right replace all the bad wires and the cuts of the last 50 years unbelievable how well build those cars are

21403A4F-E7C2-472B-B65D-A7F90E6CFD13.jpeg
 
no.JPG The choke uses a spring with a hard plastic bakealite cover and a heat tube from the exhaust manifold
 
You must log in or register to reply here.
Back
Top